杭州特价供应LDX-S-150-5开关电源 新款
- 产地：上海宝山
- 供应商：上海徐吉电气有限公司
- 供应商报价：面议
- 标签：杭州特价供应LDX-S-150-5开关电源 新款,10000,上海徐吉电气有限公司
产品库
低价格、高可靠 Low price and high reliability
105℃输出电容器 105℃output capacitor
适用AC输入电源 AC input power suitable for the world
效率高、工作温度低 High efficiency and low operation temperature
软启动电流、有效降低AC输入冲击 Soft-start current can reduce the AC input impact efficiency
有短路保护、过载保护 With short-circuit and overload protection
体积小、重量轻 Compact size, light weight
100﹪满负荷烧机测试 100﹪full-load burn-in test
内装EMI滤波器、纹波极小 Installed with EMI filter, minimum wave
型号 Mode 性能 Performance | S-150-5 | S-150-7.5 | S-150-9 | S-100-12 | S-100-13.5 | S-100-15 | S-100-24 | S-100-27 | S-100-48 |
直流输出电压 DC output voltage | 3V | 5V | 7.5V | 12V | 13.5V | 15V | 24V | 27V | 48V |
输出电压公差 Output voltage tolerance | ±2﹪ | ±2﹪ | ±1﹪ | ±1﹪ | ±1﹪ | ±1﹪ | ±1﹪ | ±1﹪ | ±1﹪ |
额定输出电流 Rated output current | 30A | 20A | 16.7A | 12. | 11. | 10A | 6. | 5.6A | 3.2A |
输出电流范围 Output current range | 0～30A | 0～20A | 0～16.7A | 0～12. | 0～11. | 0～10A | 0～6. | 0～5.6A | 0～3.2A |
纹波及噪音 Ripple and noise | 150mVp-p | 150mVp-p | 120mVp-p | 100mVp-p | 100mVp-p | 100mVp-p | 100mVp-p | 100mVp-p | 75mVp-p |
进线稳定度 Inlet stability | ±0.5﹪ | ±0.5﹪ | ±0.3﹪ | ±0.3﹪ | ±0.3﹪ | ±0.3﹪ | ±0.2﹪ | ±0.2﹪ | ±0.2﹪ |
负载稳定度 Load stability | ±0.5﹪ | ±1﹪ | ±0.5﹪ | ±0.3﹪ | ±0.3﹪ | ±0.3﹪ | ±0.2﹪ | ±0.2﹪ | ±0.2﹪ |
直流输出功率 DC output power | 150W | 150W | 150W | 150.3W | 150W | 150.2W | 156W | 151.2W | 153.6W |
效率 Efficiency | 80﹪ | 80﹪ | 80﹪ | 82﹪ | 83﹪ | 84﹪ | 85﹪ | 86﹪ | 87﹪ |
直流电压可调范围 Adjustable range for DC voltage | 4.5-5.5V | 6-8.35V | 8-10.45V | 10.6-13.2V | 12-15V | 13.5-16.5V | 21-28V | 24-30V | 43.-53V |
输入电压范围 AC input voltage range | 85～132VAC/170～264VAC由开关选择47～63Hz; 240～370VDC 85～132VAC/170～264VAC selected by switch 47～63Hz; 240～370VDC | ||||||||
输入电流 Input current | 3.2A/115V 1.6A/230V | ||||||||
冲击电流 AC dash current | 冷启动电流30A/115V 60A/230V Cold-start current 30A/115V60A/230V | ||||||||
漏电流 Leakage current | ＜3.5mA/240VAC | ||||||||
过载保护 Overload protection | 105﹪～150﹪类型：切断输出 复位：自动恢复 105﹪～150﹪ Type: pulsing hiccup shutdown reset: auto recovery | ||||||||
过电压保护 Over-voltage protection | 115%--135% | ||||||||
高温保护 High-temperature protection | …………………. | ||||||||
温度系数 Temperature coefficient | ±0.03﹪/℃(0～50℃) | ||||||||
启动、上升、保持时间 Startup .rise .retention time | 100ms 50ms 20ms | ||||||||
抗震性 Vibration | 10～500Hz,2G10min/1周期，时长60分钟，各轴 10～500Hz,2G10min/1 cycle , Period for 60 min , Each axes | ||||||||
耐压性 With standard voltage | 输入输出间：1.5KvAC输入与外壳： 1.5KvAC输出外壳： 0.5KvAC Input and output internal ：1.5KvAC input and enclosure ： 1.5KvAC output and enclosure： 0.5KvAC | ||||||||
隔离电阻 Isolation resistance | 输入输出间： 输入与外壳，输出与外壳：500VDC/100MΩ Input and output internal: input and enclosure. Output and enclosure: 500VDC/100MΩ | ||||||||
工作温度、湿度 Working temperature and humidity | -10℃～+60℃(参考输出特性图)，20﹪～90﹪RH -10℃～+60℃(Refer to output diagram cech，20﹪～90﹪RH | ||||||||
存储温度、湿度 Store temperature and humidity | -20℃～+85℃, 10%～95%RH | ||||||||
外型尺寸 Overall dimension | 199×98×38mm | ||||||||
重量 Weight | 0.7kgs | ||||||||
安全标准 Safety standards | UL1012 TUV按6050（IEC,UL1950）认证 UL 1012 TUV EN6050(IEC,UL1950) Approved | ||||||||
EMC标准 EMC standards | CISPR22(按55022)，IEC801-2,3,4IEC555 -2认证 CISPR22(EN55022)，IEC801-2,3,4IEC555 -2 Verification | ||||||||
备注： 1.以上参数测试条件为：230VAC输入，额定负载,25℃70%Rh,温度。 2．容差： 包括设定容差，线路稳定度，负载稳定度 3．纹波测试：20MHz用“A12”双绞线，中断用0.1uF&47uF电容器短路。 4．进线电压稳定度测试：满负载时进线Z低电压到Z高电压。 5．负载稳定度测试：负载从0%到 Note : 1. The testing condition for the parameter above is : 230VAC input ,rated load,25℃70%Rh. Temperature. 2. Error, include the setting error, line stability and load stability . 3. Wave test: adopt “A12”double wire for 20MHz, and 0.1UF & 47UF capacitor short-circuit for interrupting. 4. Inlet voltage stability test: when is over load, the lowest voltage of inlet is up to the highest voltage. 5. Load stability test: The load is from 0% to | |||||||||
